The Making of Seafrog

Here we are at Montgomery Boats owned by Bob Eeg home of the Montgomery Boats and the Nor'Sea boats. If you've never seen the process before, here's your chance to see how these wonderful crafts are manufactured. The following photos are of the construction of my M-17, Seafrog. There are three major components: the hull, the deck, and the pan (interior) which covers about 2/3 of the hull. (is that Bob in the second photo pushing parts around?? Definitely the hands on owner)

To make life easier there are things to be done before the three components are all put together. The liner is tabbed in. The handrails, mast step, bowrails, locker hatches and other hardware are installed. Notice the original portlight is glassed in to fit the new ports.

After tabbing in the lower portions of the pan, the deck is attached. I opted for the opening ports since it gets kind of steamy here on the outer banks of North Carolina. The photo below shows lowering the deck. At this stage only one pair of the two pairs of port holes are cut in.

With the handholds installed and the beautiful bronze portlights installed the deck is attached with epoxy and s/s nuts/bolts every 6". Here the jib rails are being installed as well.

I opted for the IdaSailor rudder. We have a lot of shoaling and very shallow water. Unexpected shallow water! So it's very nice to have this design.

With the arrival of the trailer, Seafrog gets her first glimpse of daylight. She's starting to look like a boat now. I selected a green sheer stripe to compliment the tan bark sails.

With Seafrog finished, Bob's hamming it up with his talented workers. And later, Seafrog is loaded up for her trip from California to North Carolina. She will be loaded up with two other Montys to head east. She looks so clean leaving. Wait til you see her when she gets here to NC!!